All undergraduates at Florida State University must demonstrate basic computer skills competency prior to graduation. As necessary computer competency skills vary from discipline to discipline, each major determines the courses needed to satisfy this requirement. Undergraduate majors in interior design satisfy this requirement by earning a grade of "C–" or higher in IND 3469.

The State of Florida has identified common program prerequisites for this University degree program. Specific prerequisites are required for admission into the upper-division program and must be completed by the student at either a community college or a state university prior to being admitted to this program. Students may be admitted into the University without completing the prerequisites, but may not be admitted into the program.

At the time this document was published, some common program prerequisites were undergoing revision. Please visit http://facts23.facts.org/navigation/detail_ext/cpp_intro.do?pageId=060304 for a current list of state-approved prerequisites.

The following lists the common program prerequisites or their substitutions necessary for admission into this upper-division degree program:

1. CGS 2060 or CGS 1060
2. CTE X431 or CTE X401
3. IND 3020 or IND X020 or any level two- and three-dimensional design course
4. XXX XXXX: nine (9) credit hours of art, art history, or other art-related courses; these may be taken at any level and may be used to satisfy performing and fine art and/or humanities general education requirements

The undergraduate degree program consists of a minimum of seventy-two semester hours of course work in interior design, including a minimum of six semester hours of electives. Students are urged to attend professional conferences and lectures as a vital part of the educational process.

Specific degree requirements include the following:

1. Liberal studies: of the required and elective semester hours, four should be taken in textiles (CTE 1401), and three should be taken in an art history course selected by the student. The department is prepared to offer suggestions about related courses. Refer to 'The Liberal Studies Program' in the "Undergraduate Degree Requirements" chapter of this General Bulletin for specific degree requirements. Contact the program career counselor for further information if needed.
2. Interior design studio courses: twenty-one semester hours
3. Technical and graphic design courses: twenty-one semester hours
4. Lecture-based support courses: fifteen semester hours
5. History of interiors and architecture: nine semester hours
6. Electives in interior design: six semester hours.

Requirements for Bachelor of Arts Degree (only)

1. Electives in art-related courses must also meet University humanities requirement
2. Language requirement is the equivalent of two years of language proficiency (no credit requirement).

Refer to 'The Liberal Studies Program' section in the "Undergraduate Degree Requirements" chapter of this General Bulletin for specific degree requirements.

Requirements for a Major in Interior Design

The program is a limited access major with required sequential course offerings and elective courses in interior design. Four diagnostic courses are offered the first year of study (IND 1203, 1204, 1206, and 1406). In a portfolio review of work generated from these four classes held at the end of the Spring Term (called First Year Review), the top 40 students are chosen to move forward into the second year and above studies. Transfer students may take all four diagnostic courses during the Summer term, and then go through First Year Review (their numbers counting within the total 40 students chosen to move forward).

A specific listing of courses required for a major in interior design is available on the department Web site at http://interiordesign.fsu.edu. Internship preparation and placements are available for all undergraduate students, and students are urged to elect these studies. A minor is not required, but may be obtained in other appropriate areas (departmental advisement required prior to electing a minor).

Students majoring in interior design must maintain the minimum GPA for semester and overall averages, and achieve a minimum grade of C- in any studio class in order to proceed to the next level studio .

The Department of Interior Design offers a program in honors in the major to encourage talented juniors and seniors to undertake independent research as part of the undergraduate experience. For requirements and other information, see the "University Honors Office and Honor Societies" chapter of this General Bulletin.

CTE—Clothing and Textiles

IND—Interior Design

CTE 1401. Basic Textiles (3). Introduction to fibers, fabric structure, and finishes related to selection and care. Interrelationship between textile characteristics, properties, and end use.

IND 1203. Design Fundamentals I (3). The study and development of two- and three-dimensional design projects using the elements and principles of design.

IND 1204. Design Fundamentals II (3). Prerequisite: IND 1203. The continuing study and development of two- and three-dimensional design projects using the elements and principles of design leading to the development of architectural space.

IND 1206. Introduction to Interior Design (3). A survey of the elements and principles of interior design to create an awareness of the made environment and a comprehensive appreciation of design.

IND 1406. Technical Drawing (3). An introductory architectural drafting course encompassing structural information and technical skill building in orthographic, paraline, and perspective views.

IND 2300. Graphic Techniques I (3). Prerequisite: First year review. The introduction to achromatic media used in sketching, rendering, and design drawing, with an emphasis on schematics used in problem solving.

IND 2310. Graphic Techniques II (3). Prerequisite: IND 2300. The introduction to contemporary graphics color media, reproduction processes, and presentation drawings, with a focus on the reinforcement of perspective and freehand drawing proficiencies, as well as rapid rendering techniques for interior delineation.

IND 3003. Survey of Interior Design (3). For non-majors. A survey of the elements and principles of interior design to create an awareness of the made environment and a comprehensive appreciation of design.

IND 3205. Dimensional Design (3). Exercises and experiences in fundamental design problems, with application of basic elements and principles of design. Creative studio projects in two and three dimensional design building on the graphic and technical design process.

IND 3217. Interior Design Studio I (3). Introduction to the fundamental elements and principles of design, design process, problem solving, space planning, and specifications.

IND 3306. Interior Design Graphics I (3). Graphic presentation techniques, including 1-point and 2-point perspective refinement and computer application.

IND 3404. Technical Design I (3). Introduction to basic technical aspects of interior design. Emphasis on basic drafting skills, drawing types, visualizations, and other essential technical systems in interiors.

IND 3430. Lighting Fundamentals (3). Prerequisite: IND 3217. Advanced technical aspects of interior design with emphasis on lighting, electrical plans, reflected ceiling plans, measurements, and acoustics.

IND 3440. Furniture Design (3). Prerequisite: IND 3469. The study of materials, structural considerations, function, and style of furniture and case goods by developing and appreciating their design and construction.

IND 3465. Computer-Aided Design I (3). Prerequisite: First year review. This class is an introduction to computer-aided design and drafting using AutoCAD software. Students develop an understanding of the software and how designers and architects use computers.

IND 3469. Computer-Aided Design II (3). Prerequisite: IND 3465. This course is an advanced computer-aided design class. Students increase their knowledge of 3D AutoCAD, learn the basics of Autodesk Viz software, and receive an overview of PhotoShop.

IND 3470. Construction Systems (3). Prerequisite: IND 3217. This is a lecture course that focuses on general construction techniques and terminology, integrating the building systems of structure, plumbing, and mechanical and fire safety.

IND 3474. Construction Documents (3). Prerequisite: IND 3469. A studio course focusing on the generation of a comprehensive set of specifications and construction drawings for a single project.

IND 3480. Materials and Methods (3). Prerequisite: A textiles course. This course involves the study of furnishings and finishes for interiors with an emphasis on both aesthetic and performance qualities of the materials typically utilized in interior space.

IND 3525r. Portfolio Review I (2). (S/U grade only.) A faculty review of all student work during the first semester. All students must register for this course in their first semester of registration in design. The course is based upon a knowledge of interior finish materials and internship preparation involving development of a professional portfolio. Satisfactory completion is required for continuation in the program.

IND 3600r. Design Process I (3). (S/U grade only.) The process of creative problem solving with an emphasis on application to the design process, programming, and spatial analysis of space.

IND 3930r. Special Topics in Interior Design (1–3). May be repeated to a maximum of twelve (12) semester hours.

IND 4101r. History of Interiors I (3). The study of architecture, interior, and furniture design from antiquity through the Renaissance. May be repeated to a maximum of six (6) semester hours.

IND 4131r. History of Interiors II (3). The study of architecture, interior, and furniture design of the 17th and 18th centuries. May be repeated to a maximum of six (6) semester hours.

IND 4156r. Historical Restoration, Research and Documentation (3–6). The study, research, and documentation of restoration and preservation procedures, sources of antiquities, and reproductions. Includes field trips. May be repeated to a maximum of six (6) semester hours.

IND 4161r. History of Interiors III (3). The study of architecture, interior, and furniture design from the 19th century to the present. May be repeated to a maximum of six (6) semester hours.

IND 4218. Interior Design Studio II (3). Prerequisite: IND 3217. Intermediate projects in creative problem solving applied to both residential and contract interiors. Emphasis on graphic communication and presentation.

IND 4227r. Interior Design Studio III (3). Prerequisite: IND 4218. Advanced projects in creative problem solving with emphasis on programming, spatial analysis, and open-office systems.

IND 4228r. Interior Design Studio IV (3–6). Prerequisite: IND 4227. Advanced application of the design process with emphasis on individual professional objectives and procedures for portfolio presentation. May be repeated to a maximum of six (6) semester hours.

IND 4302. Interior Design Graphics II (3). Prerequisite: IND 3306. Pencil and ink techniques used in sketching, rendering, and design drawing, with an emphasis on schematics used in problem solving.

IND 4311r. Interior Design Graphics IV (1–3). Advanced specialized study of contemporary graphic communication techniques with emphasis on individual professional objectives. May be repeated to a maximum of six (6) semester hours

IND 4315r. Interior Design Graphics III (3–6). Prerequisite: IND 4302. Marker and color pencil techniques used in interior delineation, with an emphasis on materials and the development of rapid rendering skills. May be repeated to a maximum of six (6) semester hours.

IND 4424. Technical Design II (3). Prerequisite: IND 3404. Lecture and studio course covering materials, construction, and working drawings. The focus is on structure, interior materials, millwork, finishes, hardware, and specifications. Drafting and working drawings are emphasized.

IND 4431r. Technical Design III (3). Prerequisite: IND 4424. Advanced technical aspects of interior design. Emphasis on lighting, electrical plans, reflected ceiling plans, measurements, and acoustics. May be repeated to a maximum of six (6) semester hours.

IND 4461r. Technical Design IV (3). Prerequisite: IND 4424. Computer-aided design and drafting (CADD). Emphasis on creation of interior design technical and presentation drawings using computers. May be repeated to a maximum of six (6) semester hours.

IND 4506. Business Practices (3). Prerequisite: IND 4227. This course involves advanced analysis and research into the theory and philosophy of professional interior design practice.

IND 4521. Portfolio Review II (1). (S/U grade only.) A faculty review of all student work during the third semester. All students must register for this course during the same semester they register for IND 4227 Interior Design Studio III. Continuation in the program is dependent upon a satisfactory grade in this review.

IND 4522. Portfolio Review III (1). (S/U grade only.) A faculty review of all student work after completion of the program. All students must register for this course at the same time as IND 4228 Interior Design Studio IV. The conferring of a degree in interior design is dependent upon a satisfactory grade in this review

IND 4601. Sociological and Psychological Aspects of Design (3). An exploration of the relationship between humans and their environment through the study of personal and social use of space, proxemics, spatial analysis, and the effects of the environment on human behavior.

IND 4602r. Design Process III (3). Advanced analysis and research into the theory, philosophy, and professional practice of interior design concepts. May be repeated to a maximum of six (6) semester hours.

IND 4603r. Design Process IV (3). Prerequisite: IND 4601. Advanced specialized study in creative problem solving and research of the design process with emphasis on individual professional objectives. May be repeated to a maximum of twelve (12) semester hours.

IND 4905r. Directed Individual Study (1–3). (S/U grade only.) Student has the opportunity to pursue independent work in the area of delineation or resources under the direction of a faculty member. May be repeated to a maximum of twelve (12) semester hours.

IND 4947r. Internship (1–3). Student has the opportunity to pursue experience with design firm or other related field under the direction of a faculty member. May be repeated to a maximum of twelve (12) semester hours.

IND 4970r. Honors in the Major (3). For honors credit, the Department of Interior Design requires a two-term honors program consisting of six (6) thesis or project hours to be counted toward elective credit. Upon meeting Florida State University's requirements for honors courses, the student will pursue independent creative and academic research as part of the undergraduate program.

IND 5005. Survey of Interior Design (5).

IND 5105r. History of Interiors Seminar I (3).

IND 5135r. History of Interiors Seminar II (3).

IND 5157. Historical Restoration, Research and Documentation (3).

IND 5165r. History of Interiors Seminar III (3).

IND 5175. History of Designers (2–4).

IND 5208. Design Fundamentals (3).

IND 5235r. Graduate Studio I (3).

IND 5236r. Graduate Studio II (3).

IND 5257. Graduate Studio III (3).

IND 5258. Graduate Studio IV (3).

IND 5316r. Design Graphics II (1–4).

IND 5317. Design Graphics I (3).

IND 5425. Graduate Technical Design (3).

IND 5428. Materials and Methods (3).

IND 5435r. Graduate Lighting Seminar (4).

IND 5476. Computer-Aided Design I (3).

IND 5477. Computer-Aided Design II (3).

IND 5479. Construction Systems (3).

IND 5508. Professional Practices (3).

IND 5526. Graduate Portfolio Review II (1). (S/U grade only.)

IND 5528. Graduate Portfolio Review I (1). (S/U grade only.)

IND 5609. Graduate Seminar: Social-Psychological Aspects of Design (3).

IND 5636. Graduate Seminar: Design Theory and Criticism (3).

IND 5637. Graduate Seminar: Research Methods in Design (3).

IND 5638. Graduate Seminar: Design Issues (3).

IND 5910r. Directed Individual Study (1–3). (S/U grade only.)

IND 5911r. Supervised Research (1–5). (S/U grade only.)

IND 5930r. Special Topics in Interior Design (1–4).

IND 5944r. Field Research in Space Organization (1–8).

IND 5945r. Supervised Teaching (1–3). (S/U grade only.)

IND 5948r. Graduate Internship (1–3). (S/U grade only.)

For listings relating to graduate course work for thesis, dissertation, and master's and doctoral examinations and defense, consult the Graduate Bulletin.